Optional Accessories
Model 301-LCCA Carrying Case The Model 301-LCCA carrying case is
designed to embrace the S310 or D200 indicators along with Astral calorimeters,
Vector pyroelectric detectors, and Ultra calorimeters as well as bases,
cables, and power cords.
AC25H and AC50H Calibration Heaters The heaters are mounted to
the absorber of Astral calorimeters allowing easy in-house calibrations. |
Fiberoptic Holder and Adapters The fiberoptic holder and adapters
provide direct fiber hookup to the Astral calorimeter and Vector pyroelectric
detectors (except the SP and HR models). Adapters that accept SMA, ST, FC,
DIN, E2000 connectors or any 2.5 mm ferrule are available. |
The VH STAND holds the H410 indicator upright on a table
top.
Model 301-019 Base The base holds the calorimeters and pyroelectric
detectors upright on a table top. |
| |
Model 36-0203A Isoperibol Enclosure The 36-0203A isolates the 25
mm Astral calorimeters from environmental thermal disturbances which affect
the stability of the calorimeter output when attempting low power and energy
measurements. Scientech recommends using this enclosure when attempting
power measurements below 30 mW and single pulse energy measurements below
30 mJ. |
Model 301-020R Photodiode Detector The high speed photodiode detector
is designed for use with the 25 mm Astral calorimeters as an attachment
to the calorimeter aperture. Energy scattered back from the calorimeter's
absorber when struck by an energetic pulse provides an attenuated sample
of the incident laser pulse sufficient to activate the silicon diode. This
provides a temporal profile of the laser pulse when viewed on an oscilloscope.
An internal battery eliminates all wires but the coaxial cable to the sampling
oscilloscope. |
Model VH LCC Carrying Case The Model VH LCC carrying case handles
the H410 indicators along with Astral calorimeters and Vector pyroelectric
detectors as well as bases, cables, charger, and standard protective soft
case. |
| |
|
Mounting System
This sturdy mounting system has a moldable, weighted rubber base with a non-slip surface, ball mounts, and a cradle for any of the Series S meters. This system will hold the Series S meter up to 12 inches vertically above your working surface in an upright position. The ball mounts let you reposition the meter to accommodate any viewing angle you desire. You can also readily remove the meter for safekeeping at the end of the day. |
 BasesThese bases will hold the Astral , Ultra,
and Vector
detectors upright on your working surface. Base 11788, which is a slotted base, will bolt down to your optical bench.
Base 3010
19 will work on any surface.
|
 9663 Carrying Case (soft)
Soft carrying case with belt loops.
LCC Carrying Case (hard)
Plastic carrying case for meters and detectors.
|
APX Beam Attenuators |
 Lithium Battery
The battery can be easily installed in the field or at the factory. It is a rechargeable, lithium-poly Battery with in-use time of 12 hours before needing recharging. Charging time is one hour.
| |
